Babyliss G920E Homelight Face & Body User Manual download pdf (Page 154)

156

12.2. There are no pulses when I press the release mechanism

Ensure that the application surface is evenly and rmly in contact with your skin and that the ‘Ready’ indicator

light is ashing; this indicator light guarantees that the appliance is in full contact with your skin. For your safety,

the release switch will be able to release a pulse only if the application surface is rmly pressed against your skin.

Check the control panel. If the skin colour indicator light ashes for 3 seconds, the appliance is indicating

that the the skin colour sensor sensor has assessed yours skin colour as too dark for the Homelight device

to be used safely. Try using the appliance on another area.

Check the replace ash lamp indicator light. If it is lit, unplug your appliance and change the ash lamp.

Ensure that the ‘Ready’ indicator light is lit.



If after 10 seconds, the ‘Ready’ indicator light is still not lit, turn your Homelight epilator off and turn it on

again by pressing the On/Standby switch twice.



If the problem persists, contact the BaByliss customer service in your area.

Check the appliance's appliance in use indicator light



If it is lit, turn your Homelight epilator off and turn it on again using the On/Standby switch.



If the problem persists, contact the BaByliss customer service in your area.

If these problems persist, contact the BaByliss customer service in your area.

12. Trouble shooting

12.1. My Homelight epilator won’t start

Ensure the adapter is properly connected to your Homelight epilator and plugged into the mains.

To change the replaceable ash lamp:

1. Press the On/Standby switch of your Homelight epilator to put it in standby mode.

2. Unplug the adapter from the mains.

3. Grasp both sides of the used ash lamp, pull to remove it from the socket and dispose of it in your

household waste.

4. Unwrap a new replaceable ash lamp.

5. Insert the new ash lamp gently pushing it into place.

Note: After having replaced the ash lamp, always turn the power level one notch lower than usual.

Return to your usual power level only if you experience no adverse effects during or after your treatment.

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 223 224

No comments

Babyliss G920E Homelight Face & Body User Manual Page 154